8 FT CEILING INSTALLATION
(Requires Two People for Installation)
1. Find two rafters measuring 48 inches apart on center.
2. Mark the location of each rafter.
3. Hold a support bracket over the first rafter and mark the location of the pilot holes.
4.
Pre-drill the pilot holes to a depth of 3 inches using a 5/16 inch or 9mm
drill bit.
For an easier, more secure installation and to avoid damage
to studs and hardware, make sure the drill bit length, when installed
on the power drill, is at least 3 inches.
5. Install the first support bracket to the ceiling using two lag bolts and large
washers. For quicker installation use a power drill and socket drive to drive
the bolts.
6. Attach pull up bar to second bracket using an allen bolt and small washer.
7. Insert the other end of the pull up bar into the previously mounted
support bracket, hold the second support bracket up to the ceiling over
the second rafter location and mark the location of the second support
bracket.
8. Remove the second bracket and pull up bar assembly and pre-drill the
pilot holes.
9. Attach the second bracket and pull up bar assemble to the ceiling.
10. Attach the other end of the pull up bar to the first bracket using allen bolt
and small washer.
11. Carefully examine your installation to ensure that the pull up bar are securely fastened in place before
attempting using the pull up bar.
