Page
14
of
40
Issue: 6: 08/11/2018
DRAFT
If when operating the handset the functions operate incorrectly it may be that the cables
are located in the wrong actuators. The bed will have to be carefully turned over again
and the cables will have to be inserted into the correct actuator points. The bed will then
have to be carefully put back onto its wheels and tested again to make sure the handset
operates the correct parts of the bedframe.
14. Attach the 4 mattress retaining clips over the hole on the bed frame
(
figure 11
).
15. See (
figure 12
) to see the location of where the mattress retaining clips should be fitted
on the bed frame and where the secure tags can be found. Be sure to fit the retainer bar
to the footend of the bed (figure 13)
Figure 10: Storing transport brackets Figure 11: Mattress retaining clip
Figure 12: Location of mattress retaining clips and retaining straps Figure 13. Retainer bar
Mattress retainer clip location
(same either side of platform)
Retaining straps
