10 GB/IE
Using the axle stands
1. Familiarise yourself with the function and components such as the folding mechanism and
adjustable legs. Check that the axle stands are in perfect working order.
2. Install the middle pole through the middle hole at the required height and secure it with the holding
bolt.
Note:
During use, always push the pin through the support and insertion pipes.
3.
Always secure the vehicle against rolling away as follows:
- Apply wedges for wheels
- Put the vehicle in gear ("P" on an automatic gearbox)
- Put the hand-brake on
4. The legs of the axle stands must be completely unfolded.
5. Check that the holding bolt is correctly seated (it must protrude from the other side of the middle
pole). Secure the holding bolt against slipping out with the safety pin.
6. Check that the support positions provided by the manufacturer are in prefect working order.
7. Position the axle stands under the vehicle at the points provided, or at a position that is very close
to the indicated point (see the vehicle manual).
8. Lower the vehicle slowly and carefully onto the axle stands. The axle stands must be secured and
level.
9. After using the axle stands: When removing the holding bolt, hold onto the middle pole so that this
does not fall down through the middle hole.
Maintenance and checking
Before each use, check the axle stands and the welds. Never use damaged axle stands.
There are no spare parts available for this product. In case the product is damaged or broken,
discard the product.
The holding bolt and holding mechanism must be in perfect working order.
m
WARNING! Danger of injury! Never use the axle stands or its parts for any
other use except that described by the manufacturer. The manufacturer accepts
no responsibility for incorrect use of the axle stands!
