ULTIMATE SPEED 354273 2010, Operation And Safety Notes

9 

GB/IE/NI

Safety Information

Safety Information / Using the LED light / Using the jump leads

gearboxes, put the gear lever into the neutral 
position. With automatic gearboxes put the 
gear selector into „P“.

Position the jump leads in such a manner that 
they cannot be caught up in the moving parts 
of the engine.

Using the LED light

In poor lighting conditions, the LED lights 

4

make connecting the jump leads easy. 

To switch on the LED light 

4

 set the ON/OFF 

switch 

5

 to (

I

). To switch off the LED light 

4

set the ON/OFF switch 

5

 to (

0

).

Two button cell batteries are located in each 
terminal. To replace these, remove the screws 
which are affixed directly to the ON/OFF 
switch 

5

 and remove the plastic cover. 

Please note the polarity when inserting the  
batteries (plus and minus poles).

Using the jump leads

   Connecting

EXPLOSION HAZARD!

 On no 

account should you connect the 
negative pole terminal (-) to the flat 

battery as there is a risk that sparks may fly 
and ignite explosive gases.

1.   Connect the red jump lead 

1

 with the red 

pole terminal (+) 

1a

 to the positive pole on the 

flat battery (A) an.

2.   Connect the other pole terminal 

1b

 of the red 

jump lead 

1

 to the positive pole of the donor 

battery (B).

3.   Connect the black jump lead 

2

 with the black 

pole terminal (–) 

2a

 to the negative pole of 

the donor battery (B).

4.   Then connect the other pole terminal 

2b

 of the 

black jump lead 

2

 to the vehicle chassis, e.g. 

on the earthing strap or another unpainted 
part on the engine block of the broken-down 
vehicle (A).

Note:

 The parts should be as far away as possi-

ble from the starter battery in order to prevent any 
explosive gas that may develop from being ignited. 

Note:

 If the green LED of the overvoltage protection 

3

 lights up, it means that this has been activated 

and is functioning. The overvoltage protection ab-
sorbs any potential voltage peaks. 

   Starting

After you have connected the jump leads, first 
switch on the engine of the vehicle with the  
donor battery and bring it to average speed 
(car B). Then start the engine of the broken-down 
vehicle (car A).

Note:

 After every attempt to start the car - which 

should not be longer than 15 seconds - wait for  
at least 1 minute. If you cannot start the car after 
several attempts, contact a garage. 

After successfully starting the broken-down  
vehicle (car A) wait for 2 to 3 minutes until the 
engine is running smoothly.

   Disconnecting

Note:

 Disconnect the jump leads in the reverse  

order to the way they were connected.

1.   Remove the pole terminal 

2b

 of the black jump 

lead 

2

 from the earth strap of the broken-

down car (A).

2.   Then disconnect the other pole terminal 

2a

 of 

the black jump lead 

2

 from the negative pole 

of the donor battery (B).

3.   Remove the two pole terminals 

1a

 and 

1b

 of 

the red jump lead 

1

 in any order you wish  

(A, B).

When removing the jump leads, make sure that 
they do not come into contact with the moving 
parts of the engine.