ULTIMATE SPEED 94598, Operation And Safety Notes

6 GB/IE

Lower the vehicle slowly. 

Check that all parts have been assembled 
and fitted properly and are undamaged. 

Before each use check that the hydraulic  
vehicle jack is working properly. Check the 
screws and valves of the hydraulic vehicle 
jack for correct seating and look out for  
hydraulic oil leaks in particular. 

Never 

use the hydraulic vehicle jack for 

moving or loading a vehicle. Never use it to 
lift a whole vehicle completely off the ground. 

Make sure

 that no-one – especially a 

child – is in the vehicle and that everyone is 
kept at an adequate distance away from the 
vehicle when the hydraulic vehicle jack is in 
use. 

   Never change the setting of the safety val- 

ve 

8

. It has been set at the factory and must 

not be adjusted. Stop using the product if the 
safety valve setting is changed.

   Before using the vehicle jack, the user must 

be made familiar with the device by an expe-
rienced person. The pump force and the 
transferred force are equal to approximately 
350 N.

   If the markings on the product are damaged 

enough so as to be illegible then the vehicle 
jack must not be used until the markings are 
renewed.

   No modifications may be carried out to the 

hydraulic trolley jack. Any physical modifi-
cation of the device has an effect on the 
safety of the device and its compliance with  
EN  1494 / A1:2008.

   The applied force when using the vehicle 

jack must not exceed 350 N. The equates to 
a force on the lever of approximately 35 kg.

   The operating temperature of the hydraulic 

oil of this equipment is between -20 °C to 
+40 °C. 

   Only use this device to lift and lower the  

vehicle, not to keep the vehicle in a lifted 
position. Do not move it whilst raising or 
lowering.

   After use return all parts used into their  

original position. Have the hydraulic oil or 

oil pump replaced by a professional if the 
parts can no longer be moved.

  Before first use

   Distribution of the  

hydraulic oil

With the release valve 

5

 closed, insert the 

lifting handle 

1

 into the lifting handle 

socket 

6

. Use at least 6 firm pumping 

movements to charge the hydraulic system 
(move lifting handle 

1

 up and down). This 

action distributes the hydraulic oil evenly. 

Note:

 Check that the release valve 

5

 is closed 

by inserting the lifting handle 

1

 and trying to 

turn it clockwise (see Fig. A). When you cannot 
turn it any further, the release valve 

5

 is closed.

  Using the jack

  Raising the vehicle

With the release valve 

5

 closed turn the 

lifting handle 

1

 into the lifting handle  

socket 

6

.

Place the hydraulic vehicle jack under one 
of the lifting positions as shown in the owner’s 
manual supplied by the vehicle manufacturer.

Ensure that the support plate 

3

 is centrally 

loaded. By moving the lifting handle 

1

 up 

and down, raise the vehicle sufficiently to allow 
you to insert axle stands under the vehicle 
(see Fig. B).

Allow the vehicle to come down on to the 
axle stands by slowly opening the release 
valve 

5

 by turning the lifting handle 

1

anticlockwise.

94598_uls_Wagenheber_content_GB_IE_BE.indd   6

22.07.13   14:08