ULTIMATE SPEED UMAP 12000 A1, Operation And Safety Notes Translation Of The Original Instructions

12

GB/IE/NI

Using the device

Note:

 An undervoltage protection circuit 

is installed in the portable jump starter with 

power bank 

1

 to protect the device from 

damages. This prevents a deep discharge of 

the portable jump starter with power bank 

1

 and automatically switches the device off 

once the battery is fully discharged. Shortly 

before the undervoltage protection circuit 

becomes active, the last blue indicator light 

8

  starts flashing. As soon as the under-

voltage protection circuit is active, the last 

blue indicator light 

8

  flashes and no more 

energy can be obtained. Please re-charge 

the portable jump starter with power bank 

1

.

z

Using the jumpstart feature

„

„

When using the jumpstart, make sure 

that at least 3 indicator lights 

8

 are 

permanently illuminated.

Step

LEDs

Meaning / Error

Solution

1.  Connect the jumper  

cable 

10

 of the  

portable jump starter 

with power bank to  

the vehicle jumpstart 

outlet 

9

 of the  

portable jump starter 

with power bank 

1

.

Red Error LED 

13

 is  

continuously lit on the jump-

er cable 

10

.

The voltage  

determined in the 

portable jump starter 

with power bank is 

not enough to start 

the car.

Charge the 

portable jump 

starter with 

power bank.

Green Start LED 

12

 and 

the red Error LED 

13

 flash 

alternately.

Portable jump starter 

with power bank 

ready for operation.

Carry on with 

step 2.

2.  First connect the red 

battery clamp (A) to 

the positive pole of the 

vehicle battery and 

then connect the black 

battery clamp B to  

the negative pole  

(see picture 1).

The red Error LED 

13

flashes, a short alarm signal 

sounds.

The temperature is 

too high, possibly 

due to several jump 

start attempts.

First discon-

nect the black 

battery clamp 

(B) and then 

the red clamp 

(A) from the 

battery poles. 

Start again 

with step 1.

The red Error LED 

13

flashes, a continuous alarm 

signal sounds.

Battery clamps (A) 

and (B) are the 

wrong way round.

It is caused by a short 

circuit or the battery 

is leaking.

The red Error LED 

13

 flashes 

once, a continuous alarm is 

sounded and then followed 

by two short alarm sounds.

Green Start LED 

12

 and 

the red Error LED 

13

 flash 

alternately. After 1–2 

seconds only the green LED 

12

 glows.

The connection is 

correct

Carry on with 

step 3.

3.  Starting up the 

vehicle.

322269_Mobile_Autostarthilfe_mit_Powerbank_UMAP_12000_A1_content_GB-IE-NI.indb   12

16.05.2019   13:24:41