8
GB
king any adjust -ments, changing
accessories, or storing power tools.
Such preventive safety measures reduce the
risk of starting the power tool accidentaIly.
•
Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to ope-
rate the power tool.
Power tools are
dangerous in the hands of untrained users.
•
Maintain power tools. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool’s
operation. If damaged, have the
power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
•
Keep cutting tools sharp and
clean.
Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
•
Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working con-
ditions and the work to be per-
formed.
Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Service:
•
Have your power tool serviced
by a qualifi ed repair person
using only identical replacement
parts.
This will ensure that the safety
of the power tool is maintained.
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
The mains cable is to run over the
user’s shoulder during the use of the po-
lishing machine to avoid contact with
the polished surface. This is to pre-
vent scratches from the mains cable.
Tighten cover on the
polishing disc
1. Align the polishing disc (3) upwards.
2. Using both hands, grab hold of a towel-
ling cover (5) or a synthetic fur cover (4)
and expand the elastic band outwards.
3. Put the cover (4/5) on a part of the poli-
shing disc (3) over the edge of the poli-
shing disc. Pull the cover around the edge.
4. Fit the cover (4/5) in centrally and tight-
ly around the polishing disc (3).
Switching on and off
Make sure that the power supply
voltage matches the voltage rating
indicated on the device‘s type plate.
Connect the machine to the power
supply.
1. To switch on, tilt the on/off switch (2)
to position „
I
“, the device turns on.
2. To switch off, tilt the on/off switch (2)
to position „
0
“, the device turns off.
3. Firmly hold the device with both hands
on the handle (1).
Waxing/polishing paint
surfaces
1. Use the towelling cover (5) to apply
polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
