10
GB
IE
NI
CY
Tighten cover on the
polishing disc
1. Align the polishing disc (3) upwards.
2. Using both hands, grab hold of a
towelling cover (5) or a synthetic fur
cover (4) and expand the elastic band
outwards.
3. Put the cover (4/5) on a part of the
polishing disc (3) over the edge of the
polishing disc. Pull the cover around
the edge.
4. Fit the cover (4/5) in centrally and
tightly around the polishing disc (3).
Switching on and off
Make sure that the power supply
voltage matches the voltage rating
indicated on the device‘s type
plate.
Connect the machine to the power
supply.
1. To switch on, tilt the on/off switch (2) to
position „
I
“, the device turns on.
2. To switch off, tilt the on/off switch (2) to
position „
0
“, the device turns off.
3. Firmly hold the device with both hands
on the handle (1).
Waxing/polishing paint
surfaces
1. Use the towelling cover (5) to apply
polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
3. Work with the polish in a crosswise
movement or circular motions. Exert
only moderate pressure on the surface.
4. Please refer to the information from the
polish manufacturer.
Do not allow the polish to dry out.
There is a risk or surface damage.
Therefore, do not work in direct sun-
light or on a heated surface.
Dewaxing/polishing paint
surfaces
1. Use the synthetic fur cover (4) for
dewaxing purposes.
2. Work in a crosswise movement or
circular motions. Exert only moderate
pressure on the surface.
3. Please refer to the information from the
polish manufacturer.
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
polishing disc in particular. Exchange the
damaged parts.
Summary of Contents for UPM 120 B3
Page 3: ...1 2 3 5 4 6 ...
Page 36: ...36 ...
Page 40: ...40 ...
Page 41: ...41 20191217_rev02_mt ...
