6
4) ELEMENTS INSTALLATION ON MOTOR UNIT
Before inserting the elements into the motor unit, it is necessary to fix the PVC guide
tube. During this operation it is necessary that the elements remain aligned to the motor,
if your mounting set-up does not allow this, it is absolutely required to gain assistance by
a second person to hold the support element during the insertion of the guide tube.
Inside the PVC pipe, which is going into the engine, a double-sided adhesive has been applied that will
keep the junction steady and avoid its detachment (Figure 4)
Place the PVC pipe until it reaches its maximum insertion (Figure 1)
Place the telescopic element in the motor unit until it stops and tighten the clamp of rubber sleeve.
Fig.1
Fig.2
Fig.3
Important note:
You need to carefully and correctly install the guide tubes.
In case of possible detachment of even a single tube, the copper tape will bend inevitably
damaging the motor drive functionality.
Fig.4
