Keypad — Buttons
29
Rev D
19. X100 multiplier for large values.
20. When Lbs/ft
3
is displayed the value for regenerant amount entered is
in pounds/cubic foot.
21. Faucet is displayed when the current flow rate is displayed. Control
may show the faucet and "0", indicating no flow.
22. Maintenance interval display turns on if the months in service exceed
the value programmed in P11.
23. Used with #24, #25, and #26. Displays a sequence number or a value.
24. History Values (H). The number displayed by #23 identifies which
history value is currently displayed.
25. Parameter (P). Displayed only in Level II Programming. The number
displayed by #23 identifies which parameter is currently displayed.
26. Cycle (C). The number displayed by #23 is the current cycle in the
regeneration sequence.
27. Hardness setting—only used with 760 and 762 controllers.
28. Capacity display—shows estimated system capacity.
Keypad — Buttons
Figure 18
1. DOWN arrow. Generally used to scroll down or increment through a
group of choices.
2. SET. Used to accept a setting that normally becomes stored in
memory. Also used together with the arrow buttons.
3. UP arrow. Generally used to scroll up or increment through a group of
choices.
2
1
3
4