42
PROGRAMMING THE 700 FOR 5-CYCLE FILTER APPLICATIONS
Rev D
Things You Might Need to Know
•
When the controller is first plugged in, it may display a flashing
hourglass and the message Err 3, this means that the controller is
rotating to the home position. If the Err 2 is displayed, check that the
incoming power frequency matches the controller. The North
American controller will not run with 50 Hz input.
•
The preset default time of regeneration is 2:00 AM.
•
English or Metric? The World controller senses the electrical input and
decides which is needed. The North American controller only runs on
60 Hz and defaults to English units.
•
The 700 Series controller can be programmed to regenerate on
specific days of the week.
•
If electrical power is not available, the camshaft can be rotated
counterclockwise by hand if the motor is removed.
•
The 700 Series controllers send commands to the motor for camshaft
movement. However, water pressure/flow are required during the
regeneration cycle for backwash, purge and refill, and brine draw to
actually take place.
•
Make sure control power source is plugged in. The transformer should
be connected to a non-switched power source.
•
You can start programming at the beginning by resetting the amount
of media. When viewing H0 (History Value) push and hold SET for five
seconds. The display reverts back to
---
and any programmed
information is lost. Return to
700 Series Initial Power Up
.
