If both numbers are identical you can start
charging process. If not, press BATT TYPE/
STOP button to go back to previous screen
to recheck the number of cells of the battery
pack before going ahead.
This screen shows the real-time status
during charge process. Press BATT TYPE/
STOP button once to stop the charge
process.
The value on the left side of the second lines
shows the charge current. The value on the
right side of the second lines shows the
battery pack's voltage. After setting current
and voltage, press the START/ENTER button
for more than 3 seconds to start the process.
This displays the number of cells you set up
and the processor detects.
R=Number of cells detected by charger.
S=Number of cells set by you at the previous
screen.
‘FAST' CHARGING OF LITHIUM BATTERY
Charging current will drop towards the end of charging, a specific CV
process is reduced to the charging process earlier. In fact, the
charging current reach 1/5 when the charging process comes to 1/10
during CV period, charging capacity is a little smaller than normal
charging but charging time is shorted accordingly.
Start
Enter
Batt type
Stop
>3 seconds
DEC. INC.
DEC. INC.
Start
Enter
Charged
capacity
Number
of
cells
Charging
time
Charging
current
Battery
voltage
-
-
+
+
LITHIUM BATTERY(LiPo/LiFe/LiIon/LiHV)PROGRAM
15
