Recommended Pre-Installation Procedures
- Control module
- Remote transmitter(s)
- Antenna with built in Program Button and LED’s
- 6 pin main harness with dual 30amp power inputs.
- 14 pin harness
- 3 pin keyless entry harness
- Hood pin safety switch
- Installation guide
BEFORE STARTING INSTALLATION
:
- Discuss the optional features with the customer.
- Take a few minutes to review the installation and owners manuals.
- Check if the vehicle has a factory security or anti-theft system.
*If equipped, inform the customer of addition parts and labour.
- Do a walk around the vehicle and check for any damage.
- If installing a LED discuss the placement with customer before installing.
Recommended Installation Procedures
Components
Under Hood Connections -
Route the hood pin and tach wires through the firewall into the
engine compartment. Always try to pull the wires through a factory rubber grommet. If drilling
through the firewall,
BE CAREFUL
. Check for obstructions on both sides of the firewall. After
drilling use a snap in grommet to protect the wires from sharp edges.
Proper Connections
- Remote Starters can handle loads of up to 30 amps for extended periods
of time. It is CRITICAL to insure that ALL high current connections are properly soldered and
insulated with quality electrical tape. Failing to insure proper connections will result in warranty
being VOID and can result in a FIRE. The manufacturer is not responsible for any such damages.
It only takes a few more minutes to do the job RIGHT.
Mounting The Control Module
-
Never
mount the module in the engine compartment. Select a
location under the dash to install the main module. Be certain that the module is securely attached
and does not obstruct any serviceable areas. Do not force or jam the module into tight places
instead of mounting. The module must be free from all moving parts such as brake, clutch and
gas pedals linkages. Do not place the module directly in front of a heater vent.
Installing the External Long Range Antenna
-
To insure the best possible reception, place the
antenna in the center of the windshield, behind the rear view mirror. Before attaching to the glass
ensure that the surface is clean and dry. For best results with range, place the antenna below the
tint screen. Run the cable under the head liner and behind the A-pillar panel. Be careful not to
pinch the antenna cable. Plug the antenna into the
BLUE
connector on the Control Module.
Testing The System -
When the installation is complete, it will be necessary to test that the
system is working correctly. The system’s default programming will work on the majority of
vehicles, but might need to be adjusted for some applications. If the installation requires special
timing or additional features, proceed to Program Mode.
ATTENTION: The Hood Pin Switch MUST always be connected!!
Note: Always inform user to place system in Service Mode before any service work is
performed on the vehicle.
Installation Guide Page 4
