Yellow
Starter
30amp output
12volts during crank only.
Green
Heater
30amp output
12volts in accessory off during start.
Red
12 power
30amp input
Constant 12volt power at ignition harness.
Red
12 power
30amp input
Constant 12volt power at ignition harness.
Blue
Ignition 1
30amp output
12volts in ignition and start positions.
White
Select Out
30amp output
Selectable Output. See jumper diagram.
Yellow
Re-Arm
0.75sec Pulse With Lock And On Shutdown.
Red/White
3rd CH
Trunk Release - Hold button #2 for 5 seconds
Brown
Disarm
0.75sec Pulse With Unlock And Before Start.
Orange
(-) Out
(-)While Running / Negative While Locked *
Starter Program Mode.
White/Blue
Horn
(-)Horn Honk Output *
User Program Mode
Black/White
Park Brake Negative Park Brake Input -
Manual Transmission Models Only.
Purple
(+) Door
Positive Door Input -
Manual Trans And Alarm Units Only.
White
Park Lights Positive Park Light Output -
10 Amp Max.
Green/White
Hood Pin
Negative Hood Pin Input -
MUST BE CONNECTED!!
Green
(-) Door
Negative Door Input -
Manual Transmissions Only.
Black
Ground
System Ground Input -
MUST BE CONNECTED!!
Pink
Brake
Positive Brake Input -
MUST BE CONNECTED!!
Blue/White
Tach
Tach Signal Input
-
MUST BE CONNECTED ON TACH MODELS!!
Blue
Glow Plug Programmable Input -
DIESEL ONLY. * Starter Program Mode
6 Pin Power Connector
14 Pin Connector
Green
Lock
Door Lock Output -
Programmable - Menu 1 Setting 3.
Red
12vlt Output Low current output for Voltage Inverter Only.
Blue
Door Unlock Door Unlock Output -
Programmable - Menu 1 Setting 3.
3 Pin Connector Red
4 Pin Connector Blue
Jumper Selections
Antenna/ Program Button Connector.
Position One
Second Starter
Output On the White Wire From The 6-Pin Connector.
Position Two
Second Accessory
Output On The White Wire From The 6-Pin Connector.
Position Three
Second Ignition*
Output On The White Wire From The 6-Pin Connector.
when pushed outwards from the center of the module.
The jumpers control the output on the white wire from the six pin harness. To change the output of
this wire, place the jumper in one of the following positions
To change the jumper position you must first remove the access cover from the top of the module.
Remove the cover as shown in the diagram below. The access cover will slide out of its position
Note:
Do not use the center pin of this connector to power relay packs. Doing so will damage the
output. Always use a fused power source when installing relays for keyless entry.
Page 5
Installation Guide
