Step 1 - Connect All Of the Following Wires
Main Connector (6pin)
YELLOW
Starter Output
- 12volts during start position only.
GREEN
Heater/Acc Output
- 12volts in the accessory position off during
start and 14volts during run.
RED
12volt 30amp Input
- 12volts from ignition harness or battery.
RED
12volt 30amp Input
- 12volts from ignition harness or battery.
BLUE
Ignition Output
- 12volts in the ignition, start and run positions.
WHITE*
Selectable Output
- Selectable Output for vehicles that may
require a 2nd Ignition, Accessory or Start.
*(
See jumper diagram page 7)
Auxiliary Connector (14pin)
BLACK
System Ground Input
- Connect to Chassis Ground.
WHITE
Park Light Output
- Connect to Park Light system.
GRN/WHT
Hood Pin Input
- Connect to the Hood Pin Safety Switch.
BLUE/WHT*
Tach Input
- Connect to A/C Tach source. (Above 2 volts AC)
PINK
Brake Switch Input
- Connect to (+) when the brake pedal
is applied.
*
Not necessary on TL models only.
“M” Series
(yellow cases)
BLK/WHT
Park Brake Input
- Connect to Park Brake wire.
GREEN** or
Door pin Input
- Connect to (-) wire when door open
PURPLE**
Door pin Input
- Connect to (+) wire when door open
NOTE:
Blue/White must be connected on “M” series.
**
Connect only ONE of the door input wires.
Important!
Never install an AUTOMATIC TRANSMISSION module into a
MANUAL TRANSMISSION vehicle!
INSTALL MANUAL
REMOTE VEHICLE STARTER
PAGE 10
