Menu 1 - Press
1 Flash 2 Flashes 3 Flashes
1 Ignition Lock Enabled Lock Only
Disabled
2 Horn Honk Type 1 Type 2
All Honks
3 Lock&Unlock Options Double Unlock 3 second 3/4
second
4 Unlock/Disarm 125ms
750ms
Menu 2 -Press
1 Flash 2 Flashes 3 Flashes
1 Secure Service Mode 15 seconds
5 seconds
2 Park Light Output 30 seconds (-) Park Light (+)
Park Light
3 Horn Timing 5ms 50ms
10ms
4 Button #4 ( Button) Trunk Release Garage Door
Car Finder
5 Reservation Mode Manual
Auto Reservation
Menu 3 -Press
1 Flash 2 Flashes 3 Flashes
1 Lock/ Unlock Type Type 1 Type 2
Normal
2 Gas/ Diesel Negative 15 second
Gas/Positive
3 Rearm Output Type 1 Type 2
Rearm
4 Run Time 4 Min 45 Min
15 Min
5 Crank Time 10 seconds 3 seconds
5 seconds
6 Starter Disable/GWR Active Passive
GWR
7 Safety Start Mode Press twice
Press once
Menu 4 -Press
1 Flash 2 Flashes 3 Flashes
1 Low Idle Learn
Low Idle Learn
2 Adjust For Over Crank
Reduced by 10%
3 Adjust For under Crank
Increased by 10%
**Bold type indicates settings that are Factory Default.
System Reset
The system reset will clear any changes made to the Program Menu’s as well
as the Tach setting. When the system reset is complete the system must be
Tach learned before the remote starter will operate.
1)
Turn the ignition key from “Off” to “On” 3 times,
ON-OFF-ON-OFF-ON
within
three seconds
.
(Leave the key in the
ON
position)
2)
Press and release the
Program Button
located on the antenna. The park
lights will turn on and the horn (optional) will honk one time.
3)
Then press and hold the
Program Button
until the park lights flash and the
horn (optional) will honk 3 times slowly to confirm system reset.
System is now reset to factory defaults
.
NOTE:
System Reset
does not
delete the transmitter codes from memory.
* See the following pages for more detailed programming instructions.
REMOTE VEHICLE STARTER
INSTALL MANUAL
PAGE 15
Quick View Programming
