Setting 1 Special Door Lock/Unlock Operations
(Factory Alarm Rearm)
.
1) Type 1 1 Flash/Honk Unlock before start. Lock pulse after start and shutdown.
2) Type 2 2 Flashes/Honks Lock pulse ONLY after remote start shutdown.
*3) Type 3 3 Flashes/Honks Default Lock/ Unlock Pulses.
Press & Release the Program Button 1 Time
(Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 2 Gas/Diesel Mode
(Auxiliary Connector Pin 12, 12xx series)
1) (+) Input 1 Flash/Honk (+) Glow Plug input. Waits maximum 30 seconds
.2) Time Delay 2 Flashes/Honks Waits for approximately 15 seconds.
*3) Gas/ (-) Input 3 Flashes/Honks Waits 2 seconds if no diesel input is detected.
Press & Release the Program Button 2 Times (Setting 2)
Confirmed with 2 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 2 Gas/Diesel Mode
(Auxiliary Connector Pin 12, 13xx series)
1) (-) Input 1 Flash/Honk (-) Glow Plug input. Waits maximum 30 seconds.
2) Time Delay 2 Flashes/Honks Waits for approximately 15 seconds.
*3) Gas/ (+) Input 3 Flashes/Honks Waits 2 seconds if no diesel input is detected.
Press & Release the Program Button 2 Times (Setting 2)
Confirmed with 2 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button
to proceed to the next step
.
NOTE:
Setting 2 will vary depending on the board layout 12xx or 13xx series..
Setting 3 Rearm Output (Auxiliary Connector Pin 1)
1) Type 1 1 Flash/Honk Pulse after start and with lock.
2) Type 2 2 Flashes/Honks Pulse after start only.
*3) Factory Re-arm 3 Flashes/Honks Pulse with lock and after starter shutdown.
Press & Release the Program Button
3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button
to proceed to the next step.
INSTALL MANUAL
REMOTE VEHICLE STARTER
PAGE 18
Menu 3- Starter Settings
Press and
Release the
button for
Menu 3
Ignition 3x
On/Off
On/Off On
Press and
Release the
Program
Button
Press and Release
the Program Button
# of Times for
Setting Chosen
Press and Hold
the Program Button
to Change Option
