Ultra Start 12xx Series, Install Manual

If the remote starter does not activate when the start button is pressed the park 
lights will flash a diagnostic to indicate what shutdown input has been triggered. 
For example: 

If the  

 button is pressed the park lights flash 3 times slowly. 

Looking at the chart below this would indicate that the system is in Service 
Mode, simply follow the instructions listed in the owners manual on exiting 
Service Mode  and the remote starter will begin to function as normal.   

PARK LIGHTS           STATUS LED                  DIAGNOSTIC CODE

3 Flashes                   Series of 3 Flashes          Door Opened “M” Models
3 Slow Flashes          LEDs “ON” Solid              System Is In Service Mode
4 Slow Flashes          Series of 4 Flashes          Not in Reservation Mode*
5 Flashes                   Series of 5 Flashes          Hood Open            
5 Slow Flashes          Series of 5 Flashes          Ignition On During Start Attempt
6 Flashes                   Series of 6 Flashes          Brake Pedal Shutdown
7 Flashes                   Series of 7 Flashes          Tach Lock-Out
                                                                                                 * “M” series ONLY

DIAGNOSTIC MEMORY

LED Flashes             Diagnostic

5 Flashes                   The system was shutdown by the brake switch input
6 Flashes                   The system was shutdown by the hood pin input
7 Flashes                   The system did not detect the tach signal.
8 Flashes                   The system made 3 start attempts without starting 

To Enter Diagnostic Memory Mode:
Step 1- 

Turn the ignition ON then OFF. Press and release the Program Button. 

Step 2-

 The system will respond with three park light flashes and the horn (optional) will

              honk the same number of times as the events in memory.
              

Maximum four events, four honks

NOTE: 

If the horn does not honk, there are no events in memory. 

Step 3- 

Press the Program Button once to view the last shut down code. The horn (optional)

             will honk once to confirm code one. 
             

If the horn does not honk, there are no codes in memory. 

Step 4- 

The LEDs on the antenna will flash a code corresponding to a shut down trigger.

              Press the Program Button again for the second code. 
              

The horn will honk twice to confirm code two.

Step 5- 

To 

Clear Diagnostic Memory.

 While in Diagnostic Mode press and hold the

              Program Button for five seconds. The park lights will flash and the horn (optional) 
              will honk once.

NOTE: 

 Once diagnostic memory has 4 shutdown events in memory, the system will not   

             Record any further shutdown events until the system memory has beencleared.

INSTALL MANUAL   

                                                      REMOTE VEHICLE STARTER

      PAGE 24

DIAGNOSTICS