Wiring Descriptions
MAIN CONNECTOR (6pin)
Pin Function
Description
1-YELLOW Starter Output
-
This wire will test 0V in OFF, ACCESSORY and in
the ON key positions. 12v during START ONLY.
2-GREEN Heater/Acc Output
-
This wire will test 0V in the OFF and START
key positions. 12-14V in the ACCESSORY
and RUN key positions.
3-RED 12volt Input(30amp)
-
Supplies 12votls for the IGNITION, PARK
LIGHT and SELECTABLE outputs.
4-RED 12volt Input(30amp)
-
Supplies 12 volts for ACCESSORY and
STARTER outputs.
5-BLUE Ignition Output
-
This wire will test 0V in the OFF and
ACCESSORY key positions.12V in the
IGNITION, START and RUN positions.
6-WHITE Selectable Output
-
O
utput for 2nd IGNITION, 2nd ACCESSORY
or 2nd STARTER.
AUXILIARY CONNECTOR (14pin)
Pin Function
Description
1-YELLOW Re-arm(-)
-
0.75 second pulse output when
is pressed and after
remote start shutdown.
Used for factory alarm re-arm. (Menu 3)
2-RED/
Trunk Release(-)
-
Programmable output. Hold
or
button
WHITE
for 3 seconds, output will stay active
(max 5 seconds) or (-)park light.
3-BROWN Dis-arm(-)
-
0.75 second pulse when
and is pressed and before
remote starter activation. Used for factory alarm dis-arm.
4-ORANGE Ground When Running(-)
-
Output active during remote start.
/Starter Kill
Programmable Starter Kill. (Menu 3)
5-WHITE/ Horn(-)
-
Output to activate factory horn. (Menu 1&2)
BLUE
6-BLACK/ Parking Brake(-)
-
Input to detect (-) when parking brake switch
WHITE
is applied. (“M” series)
7-PURPLE Door Pin(+)
-
Input to detect 12v when door is open. (“M” series)
8-WHITE Park Light(+)
-
10amp positive output to activate park lights.
Programmable output (menu 2)
INSTALL MANUAL
REMOTE VEHICLE STARTER
PAGE 8
