![background image](http://html2.mh-extra.com/html/ultra-start/15-series/15-series_install-manual_3441374008.webp)
Page 8
INSTALLATION MANUAL
REMOTE VEHICLE STARTER
6-pin
Description
Test For Wire
1-Yellow
30amp Starter Output
This wire will test 0volts in off, accessory and in
the ignition position.12volts during start only.
2-Green
30amp Heat/Acc Output
This wire will test 0volts in the off position 12-
14volts in the accessory and run positions and
0 volts during start
3-Red
30amp Power Input
12volts at ignition harness or from battery.
Supplies power for the ignition, selectable output
and park light relays.
4-Red
30amp Power Input
12volt power at ignition harness or from battery.
Supplies power for accessory and start relays
5-Blue
30amp Ignition Output
This wire will test 0volts in the off and accessory
position 12volts in the ignition, start and run.
6-White
30amp Select Output
Selectable output for 2nd Ign, acc or starter.
14 pin connector
Pin Number
Function
Description
1-Yellow
Re-Arm
0.75 second Pulsed output when locked and on remote start
shutdown. Used for factory alarm re-arm.
Programmable
output. See Menu 3
2-Orange
St.kill and
Negative output when locked and during remote start.
Anti-Grind
Used for optional starter disable, and anti-grind relay.
Pr
ogrammable output. See Menu 3
3-Brown
Disarm
0.75sec pulsed output when Unlocked and pulse before
remote start activation. Used for Factory Alarm Disarm.
4-Red/Wht
Trunk
Hold the unlock button for 3 seconds. Output will stay on
until the unlock button is released (Max 5 seconds)
Programmable to -Park lights. See Menu 2
5-Wht/Violet
GWR
(-) Output while remote starter is activated. Used to
activate Anti-theft bypass modules.
6- Green
(-) Door Pin
Input to detect door opening. Connect to door pin that
switches to Negative when the door is opened.
7-Green/
Hood Pin
Negative input from hood pin safety switch. Switch is
White
grounded when the hood is opened. Must be connected.
8-Purple
(+) Door Pin
Input to detect door opening. Connect to door pin that
switches to 12volts when the door opened.
9-Pink
Brake input Positive Brake Input. Used to detect the brake switch
being applied. Found at the brake switch connector.
10-Black
Ground
System Chassis Ground Input.
.
6 Pin Power Connector