Auxiliary Connectors
-
continued from previous page
11-Black
Ground
-
System Chassis Ground Input.
12-Blue
Glow Plug -
Diesel Glow plug input, detects both 12volt and negative glow
plug signals. Programmable input. See Menu 3.
13-Blue/White
Tach
-
A/C Tach Signal Input. Used to detect when the vehicle has
started. This wire is connected to the vehicles coil, fuel injector or crank
sensor wire.
14-Pink
Brake input -
Positive Brake Input. Used to detect the brake switch being
Applied. Found at the brake switch connector.
15-Wht/Violet
GWR -
(-) Output while remote starter is activated. Used to activate
Anti-theft bypass modules, adding 3rd ign etc.
3 Pin Connector Red
1-Green
Door Lock -
Door Lock Output - Programmable Menu 1 Setting 3.
2-Red
12volt Output - *
Output For Door Lock Module Only!
3-Blue
Door Unlock -
Door Unlock Output - Programmable Menu 1 Setting 3.
* The centre pin of the keyless entry harness is not to be used for anything besides
plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
4 Pin Connector Blue
RF Antenna/ Program Button Connector.
Remove the plastic from the adhesive tape and place the antenna in the center of the
windshield, behind the rear view mirror. Run the cable behind the head liner and
A-pillar panels to the module under the dash.
***The Antenna Must Be Connected Before the System will Operate.***
2 Pin Connector White
Connector for Instant Start Input or Temperature Sensor on LT models.
Note
: This Input is not available on the 3250 Series.
3 Pin Connector White
1- White/Violet GWR -
G
round output while running. This output can be used for bypass
module activation or adding additional relays.
2- Black Ground -
Low current constant ground output
.
3- Red- 12volts -
Low current constant 12volt output.
Page 9
2WAY REMOTE VEHICLE STARTER
INSTALLATION MANUAL
