Page 10
OWNER’S GUIDE
2WAY REMOTE STARTER
Cold Start Mode will start the vehicle at a user selectable start interval or
temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4
hours in Timer Mode or to start at 0,-5,-15 or -25 Celsius in Temperature
Mode
(LT Models Only)
for a maximum 12 starts. The vehicle will start at
the selected start interval/ temperature and run for the programmed runtime
(Normally 15min). Cold Start Mode must be set each time the user wishes
to use this feature.
Example- Timer Mode
. If the 4 hour start cycle was selected, the vehicle
will start once every 4 hours and run for the programmed runtime then turn
off. This setting will keep the vehicle in Cold Start Mode for up to 2 days
before deactivating.
Example- Temp Mode (LT models only)
. If the -15 Celsius start cycle
was selected, the system will monitor the temperature until it falls below
-15, at this time the remote starter will activate for the programmed runtime.
The system will then wait 2 hours before checking the temperature again.
To Enter Cold Start Mode.
Press and release button
#4
, then press and hold Button
#3
for 6 seconds
or until park lights turn on. While the park lights are on the start cycle can
be selected.
Interval/ Temperature
Press To Select
Park Light Confirmation
1 hour or 0 Celsius
Press button #1
1 Park light flash
2 hour or -5 Celsius
Press button #2
2 Park light flashes
3 hour or -15 Celsius
Press button #3
3 Park light flashes
4 hour or -25 Celsius
Press button #4
4 Park light flashes
Note:
The optional Low Temp sensor must be installed for the Temperature
Sensor settings to be available. (LT Models only)
To Cancel Cold Start Mode
Press and release button #4, then press and hold button #3 for six seconds.
Stepping on the brake or turning on the ignition will cancel Cold Start.
Cancellation of Cold Start Mode will be confirmed with two park light
flashes and two horn (optional) honks.
Cold Start/Timer Mode
1 2 3
4
