PAGE 14
72 SERIES
OWNER'S MANUAL
REMOTE PROGRAMMING
ENTERING REMOTE PROGRAM MODE
The system can lean up to 4 different remote’s. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote’s are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations.
HOLD program switch, the HORN will Honk ONCE and the park lights will turn on.
(If the HORN does not Honk repeat step 1)
CONTINUE TO HOLD until HORN Honks 5 times
Press & Release LOCK (START on the 1172) button on 1st Remote to be
Programmed for Normal
Operation
If remote(s) are to be programmed for "PADLOCK" skip and
goto step 6
Press & Release BUTTON 4 on Remote to be Programmed
for 2ND CAR OR PAD LOCK (Not available on the 1172)
HORN will Honk 1 time to confirm remote has been
programmed (If the HORN does not Honk press button again)
HORN will Honk 1 time to confirm remote has been
programmed (If the HORN does not Honk press button again)
PROGRAMMING REMOTE’S
Cycle the Ignition Key - ON/OFF ON/OFF ON (Leaving the key ON)
Turn ignition key OFF to exit remote program mode when
all required remote’s have been programmed.
1 Honk confirms program mode entered followed by 5 Honks confirming
transmitter program mode
1 -
2 -
3 -
4 -
6 -
5 -
7 -
8 -
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
PAGE 15
72 SERIES
OWNER'S MANUAL
LED 2 WAY OPERATIONS
LED 2 WAY SYSTEMS
LOCK BUTTON
When the lock button is pressed the light behind the button will flash once
and the remote will beep once as confirmation that the function has been
completed. If the system is not in range the remote will beep 3 times.
LOCK
UNLOCK
UNLOCK BUTTON
When the unlock button is pressed the light behind the button will flash twice
and the remote will beep twice as confirmation that the function has been
completed. If the system is not in range the remote will beep 3 times.
START
START BUTTON
When the start button is pressed the light behind the start button will begin to
flash, when the vehicle start the remote will flash both the start button and the
status or the system. (locked or unlocked) If the system is not in range the
remote will beep 3 times.
STATUS
STATUS UPDATE BUTTON
When the STATUS button is pressed the button will flash once the remote will
beep once. Soon after the remote will beep and flash the appropriate button
to indicate the status of the system. If the system is not in range the remote
will beep 3 times.
LED 2way utilizes a bright blue light (LED) below the button that
illuminates the button pad shortly after the button is pressed.
The transmitter will also “beep” as an audible confirmation of the
function.
