background image

PAGE 18

72 SERIES

OWNER'S  MANUAL

DIAGNOSTICS

 DIAGNOSTICS

PARK LIGHTS

LED FLASHES

DIAGNOSTICS / STATUS

3 SLOW FLASHES

LED’s ON SOLID

SYSTEM IS IN SERVICE MODE.

5 SLOW FLASHES

SERIES OF 5 FLASHES

 START ATTEMPT WHILE IGNITION IS ON

5 FLASHES

SERIES OF 5 FLASHES

START ATTEMPT WITH HOOD SWITCH OPEN

6 FLASHES

SERIES OF 6 FLASHES

START ATTEMPT WITH BRAKE APPLIED

7 FLASHES

SERIES OF 7 FLASHES

SYSTEM IS IN TACH LOCK OUT (SEE DEALER)

8 FLASHES

SERIES OF 8 FLASHES

THREE START ATTEMPTS WITH NO START

Diagnostic Mode is a tool that can help trouble shoot a start fault. If the remote 
starter fails to start i.e.: the hood is open the park likes will flash a diagnostic code. 
i.e.: 5 flashes = start attempt with hood open. If the vehicle does not remote start, 
count the park light flashes then compare it to the chart below.

The start fault must be corrected in order for the system to operate correctly. See 
your dealer for additional trouble shooting or visit www.ultrastarters.com and visit the 
support page.

We recommend that you contact your dealer if you encounter a problem with your system. If your 
dealer is not available, see 

 to locate an Authorized 

Dealer in your area. For more advanced trouble shooting tips, programming videos, programming 
PDF’s and FAQ’s please  visit 

http://ultrastarters.com/dealer_locator.html

www.ultrastarters.com/support.html

PLEASE NOTE

Applicated Security Technologies, Inc. ("AST") promises to the original purchaser to repair or replace with 
a comparable reconditioned model any AST control module ("module") excluding without limitation the 
any other accessories, including but not limited to the antenna, remote, siren and wiring harness, proves 
to be defective in workmanship or material under reasonable use during the lifetime of the vehicle it was 
originally installed, provided the following conditions have been met: the module was professionally 
installed and serviced by an authorized AST dealer; the unit will be professionally reinstalled in the 
vehicle in which it was originally installed by an authorized AST dealer; the warranty information card was 
sent to AST within 10 days of the original installation date.  Any warranty returns include a warranty return 
authorization number issued by AST, original bill or sale and be pre-paid shipped directly to AST.  After an 
initial period of 2 years from the date of installation, AST reserves the right, at its sole discretion, to 
charge a warranty processing fee of $30.00 USD.  AST does not cover the cost for return freight on 
warranty items, this cost is the sole responsibility of the purchaser.

All components included with the original packaged unit other than the module, including but not limited to 
the siren, antenna and the remote transmitters, carry a one-year warranty from the date of purchase of 
the same. Any warranty returns on components must include a warranty return authorization number 
issued by AST, original bill or sale and be pre-paid shipped directly to AST.  This warranty is non-
transferable and is automatically void if: the original purchaser has not completed the warranty card and 
mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date 
code or serial number is defaced, missing or altered; the unit has been modified or used in a manner 
contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, 
improper service, installation or other causes not arising out of defects in materials or construction. The 
warranty does not cover damage to the unit caused by installation or removal of the unit. AST, at its sole 
discretion, will determine what constitutes excessive damage and may refuse the return of any unit with 
excessive damage, including, but not limited to, overloading, moisture and physical damage.

To the maximum extent allowed by law, any and all warranties are excluded by the manufacturer and 
each entity participating in the stream of commerce therewith. This exclusion includes but is not limited to, 
the exclusion of any and all warranty of merchantability and/or any and all warranty of fitness for a 
particular purpose and/or any and all warranty of non-infringement or patents, in the United States of 
America and/or abroad. Neither the manufacturer or any entities connected therewith shall be responsible 
or liable for any damages whatsoever, including but not limited to, any consequential damages, incidental 
damages, damages for loss of time, loss of earnings, commercial loss, loss of economic opportunity and 
the like. Notwithstanding the above, manufacturer does offer a limited warranty to replace or repair the 
control module as describe above.

Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation 
on how long an implied warranty will last or the exclusion or limitation of incidental or consequential 
damages. This warranty gives you specific legal rights, and you may also have other rights, which vary 
State to State.

PAGE 19 

OWNER'S MANUAL

PRODUCT WARRANTY

WARRANTY

72 SERIES

Summary of Contents for 72 SERIES 1272





















Reviews: