3 PIN KEYLESS CONNECTOR
This connector is used when installing the optional keyless entry feature. If the door
lock type of the vehicle is not negative see the following pages for the appropriate door
lock diagram.
Pin 1- Green Wire- Negative Lock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
Pin 2- 12volt Output for Door Lock Module
This output will supply 12volts for a plug-in type door lock module. Do not use this input
to power-up relays **LOW CURRENT ONLY**
Pin 3- Blue Wire- Negative Unlock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
1 -
Cycle the Ignition Key On/Off On/Off On (
Leaving the key ON
)
2 -
Press and
RELEASE
the Program Switch 1 time.
(HORN will chip to confirm program mode entered)
3 -
Press and
HOLD
the Program Switch for until the HORN HONKS 3 times.
4 - Turn ignition key
OFF
to exit.
SYSTEM RESET
ENTERING REMOTE PROGRAM MODE
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
1 HONK confirms program mode entered followed by
3 HONK confirming that the system has reset.
1 -
2 -
3 -
Press and release the program switch (The HORN will HONK)
**If the HORN does not HONK repeat step 1-2.
Hold the program switch until the HORN HONKS 3 times.
SYSTEM PROGRAMMING -
Menu 1
PAGE 9
KE-6
INSTALL MANUAL
SYSTEM RESET
3 PIN KEYLESS CONNECTOR
BLUE
NEGATIVE OUTPUT FOR UNLOCK
RED
12+ OUTPUT FOR DOOR LOCK MODULE
NEGATIVE OUTPUT FOR LOCK
GREEN
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time.
HORN will chip to confirm program mode entered
3 - Select the Program Menu by pressing...
ENTERING PROGRAM MODE
4 - Press and Release the Switch to advance through the settings.
(
Confirmed by HORN HONK & LED flashes)
5 - Press and hold the Program Switch to change the setting
.
(Confirmed by HORN HONK)
6 -
To exit Program Mode, turn key off.
(Confirmed by Long HORN HONK)
The HORN will HONK to confirm that the system is in MENU 1
Continue to step 4.
Press Lock
Press Unlock
The HORN will HONK to confirm that the system is in MENU 2
Continue to step 4.
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM
SYSTEM PROGRAMMING -
Menu 1
PAGE 8
KE-6
INSTALL MANUAL
SYSTEM WIRING
