Version 1.05 March 2020
3
TEST REPORT
Each machine is tested prior to shipment. These are the test results for unit .
●
SPINDLE CONCENTRICITY
(.0005
” in max – 12.5 µm) By:
●
DOP-TO-SPINDLE OFFSET
(.001
” in max - 25 µm) By:
●
PLATEN VERTICAL RUNOUT
(.0003
” in TIR – 7.5 µm) By:
●
PLATEN PARALLELISM
(.0004
”/inch - 10µm) By:
WARRANTY
This warranty extends to the supplied machine only. ULTRA TEC is not responsible for any collateral losses in
which the supplied equipment has been involved.
The ULTRA TEC Faceting Machine has a 15-year warranty, for the original purchaser, for defects in material and
workmanship of all mechanical parts. Excepted are electronic and electrical components, which have a 2-year
warranty, and exempted are parts which may require replacement because of wear, including springs, rubber drive
components, and bearings. (If the unit is used under commercial factory conditions, the warranty periods are 2
years for mechanical components and 6 months for electronic and electrical components and exempted are parts
which may require replacement because of wear). Excluded from the warranty are problems resulting from misuse,
wear, modification, or accidental damage.
If the unit fails to function properly, consult your representative or call the factory to discuss the problem. If it is
found necessary to return the unit, send it in its shipping container, prepaid, with a note that briefly describes the
problem. If it is found necessary to return the unit the factory will provide by email a Return Material Authorization
(RMA), a completed copy of which must be included in the return-material shipment.
ULTRA TEC will correct the problem by repair or replacement and return the unit to you. ULTRA TEC is not
responsible or liable for unauthorized repairs, alterations, or any contingent damages.
ULTRA TEC Manufacturing, Inc.
1025 E. Chestnut Ave, Santa Ana, CA 92701, USA
Tel: +1-714-542-0608 Fax: +1-714-542-0627
e-mail: info@ultratec-facet.com
www.ultratec-facet.com
