Page of 4
2
Thank you very much for choosing an Ultra-Tow product! For future reference, please complete
the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This jack is designed for certain applications only. The distributor cannot be responsible for
issues arising from modification. We strongly recommend this jack not be modified and/or used
for any application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the jack until you have first contacted the distributor to
determine if it can or should be performed on the product.
For technical questions please call
1-800-222-5381
.
INTENDED USE
This permanent weld-
on mount sidewind trailer jack features a 28¹⁄
₂
" retracted length and 54"
extended length with 10,000 lb. lift capacity. The twin thrust bearing design inside the jack allows for
easier expanding and retracting, and heavy welding on the crank shaft increases strength. A large
3/4" pull pin easily activates the spring return mechanism when dropping the leg. Grease zerk
fittings are built in for easy greasing of the jack. The shaft end has an eased/bevel design to
eliminate sharp edges. 4" square tube design. Features a durable exterior-grade black painted finish
inside and out for corrosion resistance. Black painted jack handle (Item# 44086) sold separately.
Includes a footpad for stability.
GENERAL SAFETY RULES
WARNING
Read and understand all instructions. Failure to follow all instructions listed below may result in
serious injury.
Owner must ensure that the jack is installed according to these instructions
Never position any part of body under this product or supported load.
Fully retract/rotate jack before towing.
This jack is not intended for use as a transport device. Minimize movement of the implement
while the jack is under load.
Do not allow children to play on or around this jack while supporting a load.
Secure the load, vehicle and trailer form rolling when operating jack.
Never attempt to lift or support loads in excess of the rated strength of this trailer jack.
This jack is designed for vertical loading. Excessive side forces may cause failure and or injury.
Before moving trailer crank jack to its lowest position.
These jacks are not designed for round tongues.
Do not modify the jack in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the equipment. There are specific applications for which the
jack was designed.
Store idle jack. When jack is not in use, store it in a secure place out of the reach of children.
Inspect it for good working condition prior to storage and before re-use.
