17
4.5
Installing the batteries
•
Pull out the battery holder from the device casing.
•
Install the batteries (2 pcs Saft LS 14500) to the device. Make sure that the polarity is correct.
•
Push the battery holder back in to the device casing (refer to the picture on the manual). Make sure
that the battery holder goes on the correct side of the device so that the battery holder does not go
on top of the GPS-antenna (refer to the picture).
•
The LED-light will blink couple of times and then illuminate continuously until the satellites have
been found and the location message has been sent to the server.
If the LED-light did not blink or illuminate after installing the batteries, check the battery polarity and reset
the device by pressing the reset-button.
4.6
Wait for the device to start correctly
•
Wait for the LED to stop illuminating before closing the cover of the device. If the LED-light starts to
blink and continues to blink for one minute, the device is unable to find satellites or the device
cannot send the location message to the server.
•
If the LED-light blinks once per second the device is unable to find satellites. Move the device to
a place where there are no obstacles and the device is under clear sky. Reset the device so that
the device will try to find satellites again. To indicate a successful reset the device LED-light will
blink couple of times and then illuminate continuously.
•
If the LED-light blinks ten times per second, the device cannot send the location message to the
server. Remove the batteries from the device and check that the SIM-card is working properly,
and that the PIN query of the card has been removed. Send the APN to the device by using the
APN command or change the function of the device to SMS locating by using the SMS
command.
•
If the LED-light blinks as double blinks once per second, the GPRS-message was not successful.
Send the APN to the device by using the APN command or change the function of the device to
SMS locating by using the SMS command.
•
If you sent the device commands (K0, APN, SMS, P…), you will receive a confirmation message from
the device in couple of minutes after the LED-light has turned off. If the device is not confirming the
commands even though the LED-light has turned off, make sure that the K0-information has been
set correctly to the SIM card.
Note!
The admin user must be defined to the SIM-card before the device will accept any other commands. If
the device has been sent the K0- and other commands at the same time and the device replies only to the
K0 command, the other commands must be sent again. After re-sending the commands, the device should
be restarted by pressing the reset-button to make sure that the device will receive the commands. After this
the device can be attached on the neck of the reindeer.
4.7
Close the battery cover
Tighten the battery cover nut slightly before attaching the cover to the case, so that it does not start to spin
inside the case when you are closing the battery cover. Tighten the nut so that the cover stays in place and
the seal is tight, so that water cannot get inside the casing. Warranty does not cover the damage if water
gets inside the case, because the cover has not been tightened and closed properly.
5
SMS COMMANDS AND ALARMS
You can send multiple SMS commands to the reindeer-GPS in a row (one command in one message). The
device will handle the commands after the sending the next location message to the server.
