SINGLE LEVER CONTROL B301 AND B302
-
page 9
of 47
Installation and maintenance manual
ULTRAFLEX
E
N
G
L
ISH
3.4 Connecting control cable
1
Select a direct path with a minimum number of bends and without any obstacles.
Avoid too narrow bends (the minimum bend radius is 203 mm (8")).
WARNING
NOTICE
Outboard engine installations require an additional length of about 120 cm (47") of the cables to allow
engine swing.
The cables can be fixed with suitable cable hangers (supplied separately) or routed through segments of
conduit (supplied separately too) for long straight runs.
WARNING
2
CONTROL B301:
Remove the rear
cover
(4)
of the control
by (unscrewing) the
screws
(5)
so as to
reach easily the
elements where the
cables are to be fixed.
4
5
5
CONTROL B302:
Spilt the two boxes
(6)
, by removing
the screws
(5)
.
5
5
6
6
3
A specific fitting kit is available for each cable type, K59 kit is also included with both single levers
B301 and B302.
To install the cables on the control/controls follow the instructions provided with each kit.
To install the cables C14 and MACH14 follow the instructions given below.
B 301
B 302
5
Apply threadlocking
low strength
(Loctite 222) on the screw (3) and fasten it completely.
Insert the pin on the screw (2). Insert the rubber cover (1).
Make sure the chosen angular position allows the correct stroke of the cable.
WARNING
3.5 Installation of cables C14 and Mach14
3.5.1 Shift cable connection
1
Position
the
control box on a plane
surface as in the
picture (the Ultraflex
logo on the lever must
be visible).
Remove the cable
fastener (7) from the
plate (8) through the
screws (9).
2
Mount the cable
making sure the
cable cylinder (10) is
placed inside the
plate hole (11).
7
8
9
10
11
To avoid the control stiffening, do not fix the cables near the control outlet (the minimum fixing
distance is 500 mm) and in any case do not use fixing systems that can deform the cable conduit.
