8
2.4
CAMERA MOUNTING FOR HEG SERIES HOUSINGS
This section contains comprehensive instructions for installing a
camera into any of the HEG series housings. If you are installing
optional equipment, such as a heater/blower kit, please consult
the previous section in this manual that is appropriate and refer
to this section when instructed to do so.
1. If applicable, remove the sunshield by snapping it off of the
main housing unit.
2. Loosen the three Phillips panhead screws located on the rear
of the housing unit until they release the body of the housing.
Leave the screws intact in the rear portion of the housing.
Also loosen the set screws on either side of the external
mounting plate.
(See Figure 10)
3. By sliding the housing shell away from the rear portion of the
unit, separate the housing into two sections. It may be
necessary to unscrew the ground wire connection on the
silver camera mounting plate. However, be careful not to
disconnect the end of the ground cable that is attached to the
housing shell.
(See Figure 10)
4. Locate the following parts that are taped to or enclosed in
the housing: two black plastic plates, a nylon washer, and
three hexagonal screws of varying lengths for camera
mounting; two hexagonal screws with two metal washers;
and two Phillips panhead screws with nylon washers and
rubber gaskets. Set these parts aside for later use.
FIGURE 10
