4
11. To mount your camera, consult the section Camera
Mounting for HEG Series Housings on page 8. Begin with
step 5. Then see UL-WB+BJ & UL-WBM Wall Bracket
Mounting on page 11.
2.2
HEG14-HK HEATER KIT INSTALLATION
(without blower)
This section contains instructions for installing the heater kit for
the HEG14 and HEG14-01 camera housings. If you are also
installing the blower unit, please skip to page 6 for
comprehensive instructions.
While this heater kit is sold as an add-on component for the
HEG14 and HEG14-01, it is also available in a preassembled
package. The HEG14-02 is a 14-inch camera housing with an
installed sunshield and heater. The HEG14-03 adds a blower kit
to the HEG14-02.
1. If applicable, remove the sunshield by snapping it off the
main housing unit.
2. Loosen the three Phillips panhead screws located on the rear
of the housing unit until they release the body of the housing.
Leave the screws intact in the rear portion of the housing.
Also loosen the set screws on either side of the external
mounting plate.
(See Figure 4)
3. By sliding the housing shell away from the rear portion of the
unit, separate the housing into two sections. It may be
necessary to unscrew the ground wire connection on the
silver camera mounting plate. However, be careful not to
disconnect the end of the ground cable that is attached to the
housing shell.
(See Figure 4)
FIGURE 4
