Step 7
Step 8
Determining center post locations
Step 9
Loosely lay center post over deck edge and adjust as required to
determine fi nal center post mounting locations. (See Dia. 9 & 10)
TOP VIEW
Cut top and bottom rail glass extrusions
Measure and cu
Note: Bottom vinyl should be cut with bottom rail extrusions, top rail vinyl
should be removed before cutting. (See Dia. #11).
Snap component bottom support leg into bottom rail assembly so
mounting hole faces inward to deck surface. (See Dia.
#12).
TOP VIEW
TOP VIEW
Installation of top and bottom glass extrusions
Starting at end post or top stair post (Dia. #13) install the bottom rail extrusion,
rail glass extrusion, without the vinyl installed, onto the upper rail attachment
clips.
Secure the posts to deck surface, then secure top rail glass extrusion to top railing
attachment clip (Dia. #13A&B). Continue working from one post to the next. Install
next piece of bottom rail, then secure the top rail extrusion to the rail clips
until all rail sections are fastened to posts and posts are secured to deck surface.
Center bottom support legs between posts and fasten to deck.
Measure and Cut
t
o fit b
etween posts
TOP AND
Dia. #9
Dia. #10
Dia. #11
Dia. #12
Dia. #13
2X INSTALL
#8 TEK SCREW
2 OUTSIDE
2 INSIDE
ATTACH RAIL CLIP
TO POST USING 2X
#8 TEK SCREWS
Dia. #13A
Dia. #13B
