Connect your headphones and MIDI cable. The MIDI cable
should run from the Midinome, to the MIDI IN of the device
receiving MIDI signal.
Next, connect the power. The LED will flash red for about 3-5
seconds after that the LED will stay lit indicating that the Midinome
is ready to go.
Press the
Start/Stop
footswitch, you should see the LED light
flashing, indicating that there is both a MIDI Clock and an Audio
Click or CV Clock being sent. The default metronome tempo is 120
BPM, and will reset to this tempo when the Midinome is powered
down (unless you have saved a different tempo in the menu or
during operation). Adjust the metronome volume to desired amount.
You’re all set!
Adjusting the tempo is as easy as tapping the beat you’re
thinking of, Midinome will adjust immediately. (Takes two presses
minimum). Press Start/Stop to immediately issue a MIDI ‘Stop’
command, and stop both the MIDI Clock, and the Audio Click or CV
Clock.
Press Start/Stop again to resume.
That is all you need to know about basic operation of
Midinome!
9
