Property of Ultrasonic Power Corporation -
© 2021
Publication Number UPC211216-003
22
6.4. HEATERS
1. Remove power from the system.
2. Check heater fuses located on the inside of
the control panel.
3. Check heater pad for proper contact with the system tank.
4. Check for loose or damaged wires.
If damage is visible, contact Ultrasonic Power Corporation service department for repair
or replacement.
6.5. PUMP, FILTER & PRE-STRAINER (OPTIONAL ACCESSORY)
1. Remove power from the
system.
2. Check
pump
fuses
located on the inside of
the
control
panel.
Replace fuse as needed.
3. Turn both filter valves to "OFF" Position. Unscrew filter housing and replace filter.
Hand tighten filter back in place.
System Pump
