www.ultratecfx.com
13
DMX Operation
The Power Fog Industrial is equipped with DMX controls as a standard feature.
1. Attach a DMX signal to the DMX IN 5 pin connector on the rear of the unit. A terminator may be required on the
DMX OUT connector in some applications.
2. Select a valid DMX address on the thumbwheel selector for the base address of the fogger. If an air option is present
3 consecutive address will be required. Base DMX= fog rate controlled 0-100%, DMX+1=LSG power on above
50%, and DMX+2= air on above 50%.
3. Valid DMX LED is on solid if good DMX signal is present. DMX control overrides hand remotes. Slow or irregular
flashing indicates poor DMX data. A steady flashing indicates factory test mode and DMX switches were in the 600-
699 range at power-up. Reset switches to required address and cycle the main power switch.
Maintenance
Exterior
The casing of the PFI is stainless steel with a powder paint coating. To clean simply wash with mild soap and warm
water.
Heat Exchanger
Using high quality Ultratec Special Effects fluid should result in a long heat exchanger life. (See warranty policy outlined
on the last page of this document).
Recommended Fluid
Director’s Choice Fog Fluid:
The choice of professionals. Director’s Choice creates a cloud of fog with a medium hang
time while remaining clean, white, dry, and odorless.
Pro Beam Long Lasting Fog Fluid:
With a hang time 2-3x greater than the Director’s Choice Fog Fluid, the Pro Beam
solution produces a slightly less white fog while remaining clean, dry, and odorless.
Quick Dissipating Fog Fluid:
This fast dissipating fluid is great for applications or effects that require quick dissipation
of fog. It produces excellent steam effects that resemble nitrogen bursts and it also keeps low-lying fog from rising too
quickly when it is used with the LSG or LSX.
Extra Quick Dissipating Fog Fluid:
Dissipates 2x the rate of Quick Dissipating Fog Fluid while maintaing similar
characteristics.
Molecular Fog Fluid:
A faster dissipation versus the Director’s Choice Fog Fluid. This thick, clean, white fog is an
optimal solution for a dense low-lying fog effect when chilled with the LSG or LSX machines.
Party Fog Fluid:
Quality fog fluid on a budget. An excellent solution for Djs, Nightclubs, Haunted Houses etc., looking
to enhance light beams and creating various smoke effects.
Maxi Fog Fluid:
The perfect balance between price and performance. Maxi Fog is the ideal solution for those who
require high volume without compromise.
Maintenance Fluid
EZ Kleen Preventative Maintenance Fluid:
Using EZ Kleen preventative maintenance fluid on a regular basis ensures
longer life for the heat exchanger in Ultratec fog machines by reducing blockage.
All of our Fog Fluids are water based. Damage will occur if Haze Fluid is used in the Power Fogger Industrial
& Power Fog Industrial 9D.
