Warnings!!
Safety Precautions!!
2
1.) Do not remove air lines while unit is pressurized / energized.
2.) Persons suffering from asthma or allergenic sensitivity may experience irritation, discomfort or
allergic symptoms when exposed to fog effects.
3.) Ensure that this unit is grounded at all times. Failure to do so may result in serious injury.
4.) Use caution when walking around unit in the energized / up position. Unit could be a trip hazard.
5.) Keep hands and feet away from floor pocket opening when de-energizing unit to avoid pinching
between the metal plates.
6.) Do not stand on the Floor Pocket top plate when in the up position as damage could occur to the
non-rotating cylinder.
1.) Ensure that any operation of the machine is supervised by suitably trained and authorized
personnel.
2.) Do not modify the machine or use a machine which has been damaged in any way.
3.) Allow sufficient air circulation around the machine at all times.
4.) Protect the machine from direct weather effects and wet locations.
5.) Only use fluids manufactured by Ultratec Special Effects.
6.) Do not continue to produce fog when visibility is reduced to 20” 50cm or below.
7.) Avoid directing fog output continuously at people.
8.) Ensure that adequate exhausting arrangements are available in the event of an emergency.
9.) Do not place hands near the floor pocket when operating.
10.) Do not stand on the floor pocket when operating.
11.) Fog effects can trigger smoke alarms and detectors. Please take suitable precautions to prevent
false alarms.
12.) Slip Hazard!! Chilled fog can accumulate as liquid or moisture on the surrounding floor around
the Floor Pocket opening.
www.ultratecfx.com
WARNING!!
WARNING!!
