1) Energize the controllable power source to open / lift the Floor Pocket top plate.
2) De-energize the controllable power source to close / lower the Floor Pocket top plate.
NOTE: The rate of speed for opening and closing the floor pocket can be adjusted using the 2 flow
valve adjustment screws located on the non -rotating cylinder.
2 flow adjustment screws
The Directional Diverter may be removed if 360 degree output
from the floor pocket is desired.
This is done by removing the 2 nuts under the floor pocket lid that
hold the diverter in place. Ideally this should be done before
installation.
Operation
Photo of Floor Pocket As Seen From Below
5
Floor Pocket Directional Diverter
www.ultratecfx.com
Downward Speed
Adjustment
Upward Speed
Adjustment
