IND Operating Manual
12
C6000507
Ultrasonic Unit Operating Instructions
Before placing items in the IND-Series to be cleaned, the liquid will need to be
degassed. Turn on the ultrasonics for at least 10 minutes to degas the cleaning liquid.
(See page 15 for more details on degassing).
The IND-Series is now ready to use.
To switch on the ultrasonic activity:
Press the CYCLE key. The CYCLE light will glow, activity will commence in the liquid
and the display will count down from the set time.
(The factory pre-set time is 10 minutes.)
At the end of the timed period the activity will stop and the timer will revert to the
pre-set time, ready for a repeat of the operation.
To stop the sonic activity at any time, press the CYCLE key.
To operate the heater:
Press the HEAT key. The HEAT light will glow, and the liquid temperature will rise until
it reaches the set temperature (the factory pre-set temperature is 50 °C.)
Once the desired temperature has been reached, the HEAT light will flash indicating
that the set temperature has been reached.
NOTE:
Ultrasonic activity itself will heat the liquid, meaning that the liquid
temperature may rise above the set level. When the °C NOW Mode is selected, the
display will show the actual liquid temperature.
At the end of the cycle, remove the basket from the ultrasonic cleaner and rinse the
items under clean running water.
Change the cleaning liquid at regular intervals. Your cleaning process will determine
how often to change the liquid
–
the more soiled your items, the more often you will
need to change the liquid.
