5
Quick guide
Pour cold water into the bath so that it
submerses the level sensor (Do not
overfill).
Add the required dose of detergent (see
page 21).
In order to save the cycle data to the
memory card, ensure that the memory
card is installed in the port prior to
turning the machine on (see page 19).
Switch on the machine via the switch at
the rear of the unit, just above the
electrical mains lead.
Press the “START” key to accept the
programmed cleaning cycle settings and
start the cleaning cycle.
At the end of the cycle, remove the
basket from the bath and rinse the items
under clean running water.
The lid can be inverted and the basket
placed on top to catch excess fluid as the
items dry.
REMEMBER
-
Always ensure the liquid is above the level sensor when in
operation.
-
Do not put hot water above 50°C into the bath.
-
Always use the basket.
-
Never expose hands to cleaning solutions.
-
Never use toxic, flammable, acidic, caustic or corrosive solutions.
-
Never breathe the fumes from strong solutions.
-
Rinse the items in clean water once the cycle is complete.
Subjecting the bath to improper treatment or misuse will invalidate the
warranty.
Fluid level sensor
