Ultre5400 - User Manual
3-3
Control Panel - 3
■
Push Button Controls
■
Jog Button
The Jog Button permits the manual operation of the film advance. As long as
the button is held depressed, the film will advance, the LED will be blinking on
and off, and the LCD will display "FILM ADVANCE". Releasing the Jog
Button will cause the film to stop advancing, the LED to stop blinking, and the
LCD will display "READY". This can be used for added inter-job spacing, for
checking on film feeding when reloading film, and for confirmation of the
operational status of the drive circuit.
■
Film Advance Button
Depressing the Film Advance Button will automatically advance the film by
the number of inches that has been programmed into the film advance register
(See "Changing Default Settings" on page 5-1, for setting film advance length).
While the film is advancing, the LED will be blinking and the LCD will display
"FILM ADVANCE". When the film has stopped advancing, the LCD will
display "READY" and the LED will stop blinking. The OOMS (Out Of Media
Sensor) and the JAM Sensor are ignored when a Film Advance is performed
during the film loading procedure (described in section 4).
