2-4
Edition October 1996
2 - Introduction
■
Mains Connection
The Ultre 5400 can be connected to mains supplies as indicated on the unit
serial number plate (nominal input 115 V or 230 V AC, 50 or 60 Hz). The unit
power supply will automatically be switched to the matching supply voltage.
To connect the unit to the mains supply, use the power cord set provided with
the unit or refer to the tables following to select a commercially available cord
as specified.
Switching off the Imagesetter from the rear panel does not disconnect the unit
from the mains supply. To disconnect the Ultre 5400 from the mains supply,
remove the power plug first. The mains outlet must be easily accessible.
