3-10
Edition October 1996
3 - Control Panel
■
Machine Operation
Power is turned on by depressing the rocker switch on the machine's back panel
(see "On/Off Switch" on page 2-8). The green LED on the control panel will be
lit and the LCD will display "READY". If it does not, refer to "Error Messages
and Corrective Procedures" on page 6-5.
In normal operation, the Ultre 5400 is controlled by the host system, and
operational procedures are limited to the removal of exposed film in the Take-
up Cassette and replacement of the Take-up Cassette on the machine.
While printing is taking place, the Primary Drive Roller will be advancing the
film through the machine. The LED will be blinking and the LCD will display
"PRINTING".
When the job is finished, depress the Film Advance Button. This will
automatically advance the exposed film by the number of inches that has been
programmed into the film advance register (the default advance is 12 inches;
See Chapter 5, "Changing Default Settings" for setting film advance length).
This amount should be enough to place the last exposed copy safely inside the
Take-up Cassette. Wait until the LCD displays "READY" and the LED stops
blinking before proceeding to the next step.
