Ultre5400 - User Manual
3-11
Control Panel - 3
Operate the knife by depressing the Cut Button. The LCD will display "CUT"
for less than 1 second. The film will then advance inside the machine past the
upper rollers, the LCD will display "FILM ADVANCE", and the LED will
begin blinking. When the film stops advancing, the LED will stop blinking and
the LCD will read "REMOVE CASSETTE".
The Take-up Cassette may be removed by lifting straight up. The LCD will
display "NO CASSETTE". Approximately 2 inches of film will be protruding
from the cassette as a leader for processing. Follow the manufacturer's
instructions for preparing the leader for threading into the processor.
ATTENTION:
Wait until the LED has stopped blinking and the LCD reads
"REMOVE CASSETTE" before removing the Take-up Cassette. Failure to do
so may result in
exposing
the film in Take-up Cassette.
After processing the exposed film, the copy may be evaluated for density. If
required, the current programmed density can be changed (See Chapter 5,
"Changing Default Settings", for changing density setting).
When the input film supply is exhausted, the LCD will display "OUT OF
MEDIA". If the film has jammed, the LCD will display "JAM".
