Ultre 5400 - User Manual
4-3
Loading - 4
2. Remove the spool assembly from the supply cassette. The shaft of the spool
assembly is notched to accommodate the following media widths: 150, 200,
250, 280, *305, 310, 338, 355, 380, *400, *406 mm.
On the left side of the spool assembly is a brake mechanism and an end bell
assembly. On the right side is a spring loaded end bell assembly. As you
depress the thumb release button, remove the right side end bell from the shaft.
(Ref:Fig.2)
3. Push the thumb release button on the left end bell (next to brake) and adjust the
end bell for the desired media width.
(Note special instructions for 305,400
and 406 mm media widths on page 4-4 and 4-5. )
.Make slight adjustments
with the thumb release button until the end bell assembly locks into the appro-
piate notch on the shaft. (Ref:Fig.2)
Brake mechanism
End bell assembly thumb
release button
Fig. 2
