4-16
Edition October 1996
4 - Loading
ATTENTION:
Before proceeding to the next section, ensure the following:
●
The film is being
fed straight
(skewed film will track to one side).
●
The are no
wrinkles
or
slack
in the film exiting the Supply Cassette.
●
The film is centered as it protrudes from the exit guides.
If everything is in order, skip the next section and proceed to step 4. If
corrective action is required, proceed to the following step .
Perform these steps if there are wrinkles or slack in the film, or if the film
requires repositioning.
●
Raise the Pressure Roller Lever to the
up
(disengaged) position.
●
Grasp and straighten the film at the top of the machine.
●
Ensure that the supply cassette is positioned properly.
●
Push the Pressure Roller Lever to the
down
(engaged) position.
4. Close the Film Access Door.
5. Depress the Film Advance Button. The exposed film will move upward
through the exit guides. While this is occurring, the LCD will display "FILM
ADVANCE" and the LED will begin blinking.
The Primary Drive Roller will stop turning when sufficient film has advanced
through the exit guides. Wait until the LCD displays "NO CASSETTE" and the
LED stops blinking before proceeding to the next step.
