4
3. Installation / Storage
3-1. Precautions in Installation / Storage
3-2 Installation / Storage and Ambient Condition during Operation
This pump is a machine having precise clearance. Satisfy the following requirements when conducting
storing, installation and operation.
(1) Altitude / temperature and humidity when operating
Lower than 1000 m (3281') 0
℃
to 40
℃
in temperature, Lower than 85% (relative humidity) in
humidity.
(2) Miscellaneous (applicable both storing and operation)
a. Level location where enough floor strength.
b. No condensation.
c. No dust.
d. Well ventilated indoor.
e. No explosive gas.
f. No direct sun rays.
g. No flammability risk.
h. When Equipment is installed, temperature in pump circumference shall not exceed 40
℃
(104 degF).
3-3 Installation location
Select a location where dust and moisture are small, and install the equipment in level at the
installation location. Arrange considering work such as mounting, detachment, inspection, cleaning of
a pump.
In case building in equipment, pay enough attention to ambient temperature in particular. Loosen from
the equipment by using a rubber cushion, etc. so that no vibration may be conveyed between the
pump and equipment.
Refer "3-2 Installation / Storage and Ambient Condition during Operation" for ambient conditions.
See "Warning" (1) (2) (3) (5) (6) (7) (8) (9) (10) (11) (12) (13)
on P. 04.
See "Caution"(1) (2) (3) on P. 05.
See "Attention" (1) (2) (7) on P. 06.07.
WARNING
CAUTION
ATTENTION
