DC Power Supply
【
DC-10-D/DC-20-D/DC-10-DH/DC-20-DH
】
3. Preparation
-15-
In single-unit
In P/S connection Example: 3-unit connection
UNIT1
UNIT2
UNIT3
If the settings are incorrect, the system is put into a warning state and becomes unable to output
them.
*By changing the setting value, the limit value (SET/LIMT/IGNV,VOLT,CRNT,POW) is initialized.
Please note that if the limit is set, it will need to be reset when the unit is replaced.
*For detailed menu structure, please refer to Table 4-9. The MENU number is A15 to A18.
3-3-5 Interlocks for use as a system
Set the interlock only for Unit1.
Figure 3-6: Interlocks for use as a system
3-4 Protection Sheet
A protection sheet is attached to the top board of the product to prevent contamination. Remove it
before operation.
Protection sheet
(White color)
When unpacked Before operation
(a protection sheet attached)
(Remove the protection sheet.)
Figure 3-7: Protection sheet
Interlock pings only for Unit1
Set up (USER1: pins between 37 and 34; or
USER2: pins between 1 and 5).
[5-2-1 Pin assignment of USER1 PORT]
[5-2-2 Pin assignment of USER2 PORT]
[5-2-3 Precautions for wiring of USER IO
PORT]
Refer to the sections above.
Unit1
Unit2
Summary of Contents for DC-10-D
Page 87: ......
