4. Remove the oil filler cap(2)and drain bolt(3)-
to drain the oil from the final transmission case.
5. Install the final transmission oil drain bolt,and
then tighten it to the specified torque.
6. Add the requested amount of the recom-
mended final transmission oil, and then install
and tighten the oil filler cap.
7. Check the final transmission case for oil
leakage. If oil is leaking please contact your
dealer.
Tightening torque: 18Nm
WARNING
• Make sure that no foreign material enters the
final transmission case.
• Make sure that no oil gets on the tire or wheel.
Transmission Oil capacity:
50cm. 0,14l (Full) 0,13l (Change)
125cm. 0,12l (Full) 0,11l (Change)
4 - stroke engine oil
Recommended:
Liquid Moly SGL 4 85W-90
AIR FILTER
The air filter should be replaced according to
the maintenance schedule. Replace the air filter
more often if you drive in unusually wet or dusty
areas.
Replace the air filter
1. Remove the air filter case (1).
2. Pull the air filter out.
3. Replace the filter with a new one.
4. Coat the mating surfaces of the air filter case
and air filter case cover lightly with grease for
an airtight seal.
5. Install the air filter.
6. Install the air filter case cover by installing the
screws.
3
3
36
USER’S MANUAL
UM MOTORCYCLES CHILL EURO V 50 - 125
Summary of Contents for CHILL EURO V 125
