Table of Contents
Index
nents.You must use shielded interface cables to comply with FCC
requirements for radio-frequency interference. (All cables provided
with your SuperMac J700 are properly shielded .)
Connecting the Power Cable
Always make sure that your SuperMac J700 computer is plugged into a
grounded AC power outlet before you connect a component to it. This
properly grounds the computer.
WARNING:
Check to see that the voltage switch on the back of your
computer, located just above the power cable socket, is properly set before
you plug it in. If you need to change the setting, insert a screwdriver in the
slot and slide the switch. Set the switch to “115” for voltages in the 100-130V
range. Set the switch to “230” for voltages in the 220-240V range. If you
don’t know the voltage used in the country you’re in, refer to the table,
“Voltages for Different Locations,” in Appendix A.
To connect the power cord to your SuperMac J700:
1.
Insert the end of the power cable with the socket into
the recessed socket on the back of the computer.
Mouse
SuperMac J700
Power and ADB cables for SuperMac J700 are included. Video and power cables for
your display, if not included with your display, must be purchased separately.
Keyboard
Display
Power cable
Power cable