Installation on PC
Interface Card Installation
Follow the steps below to install the card into an available 16-bit expansion slot*:
1. Turn off your computer and unplug the power cord.
2. Remove the housing cover from the computer. (Follow the instructions provided in the computer’s
reference manual).
3. Unscrew and remove the expansion slot cover from an empty expansion slot.
4. Gently insert the interface card into the slot until it is firmly seated in the slot.
5. Secure the card’s mounting bracket in place with the screw from the expansion slot cover.
6. Replace the housing cover. (Following the instructions provided in the computer’s reference
manual).
Warning:
Static electricity can cause severe damage to your computer system and scanner, review
the section entitled “Maintenance: Static Electricity Precautions.”
* Your scanner connects to your computer via a SCSI connection. A proprietary card is provided to
make this connection. If you have an Adaptec compliant card already installed in your computer go to
next section “Connecting the Scanner and your PC”.
Connecting the Scanner and Your PC
Now that the interface card has been installed in the computer, the scanner can be connected. To connect
the scanner and computer, do the following:
1. Turn off your computer and unplug the power cord.
2. Locate the supplied SCSI Cable. Connect the 25-pin cable connector to the interface card you just
installed in your PC.
3. Attach the other end of the cable to one SCSI port of your scanner.
4. If your scanner is not chained to other SCSI devices or is the last device on the SCSI chain, please
connect the Terminator to the remaining SCSI port of your scanner.
5. Connect the power adapter to the scanner.
6. Turn on the scanner
7. Turn on the computer.
10
